Advertisement
42. Inspect the bushing and needle bearing in the end of the input shaft for wear or damage.
Under normal use, the needle bearing and bushing should not require replacement.
If replacement is required, the bushing and needle bearing must be replaced as a set.
43. If required, remove the front yoke to flange seal by prying and pulling on the curved-up lip of the yoke
to flange seal.
44. If required, remove the internal snap ring retaining the front output shaft ball bearing and remove the
bearing.
REASSEMBLY
CASE ASSEMBLY
1. If ring gear was removed for replacement, align serrations on OD of new ring gear with those in transfer
case. Press in ring gear, chamfered end first. Make sure gear is not cocked and is firmly seated in
case.
2. If removed, press two new dowel pins into case.
3. Press in ball bearing to bottom in transfer case and install retaining ring.
4. Position new oil seal and press in to seat seal flange against transfer case.
Advertisement
