Advertisement
Do not bend the helical cam during installation to the front case because of possible damage to
the pin at the tang end of the motor shaft.
40. Install the shift rail through the high-low shift fork and make sure that the reverse gear shift rail is
seated in the front case bore.
41. Install upper and lower speed sensors into the cover. Feed the coil wire through the upper speed
sensor wire shield.
42. Install upprr tone wheel, speedometer gear and rear output seal.
43. Coat the mating surface of the front case with sealant.
44. The following procedure must be followed prior to installing the rear case onto the front case half :
(1) Align the output shaft with the rear case output shaft bore.
(2) Align the helical cam with the rear case motor bore.
If difficulty is encountered with seating the rear case, tap the rear output shaft with a sharp blow
using a rubber mallet in a direction away from the triangular shaft while pushing down on the rear
case.
45. Install the bolts retaining the case halves and tighten to 25 - 37 N·m (250 - 370 kg·cm, 19 - 25 lb·ft).
Advertisement
