Advertisement
6. If the input shaft needle bearing and bushing were removed, install a new bearing and bushing.
7. The recessed face of the sun gear and the snap ring groove on the bearing outer race should be
toward the rear of the transfer case.
8. The stepped face of the thrust washer should face toward the bearing.
9. Slide the sun gear, thrust plate and thrust washer into position on the input shaft.
10. Press the bearing over the input shaft.
11. Install the external snap ring to the input shaft.
12. Install the front planet to the sun gear and input shaft.
13. Install the internal snap ring to the planetary carrier.
14. Place the tanged snap ring in the case.
Expand the snap ring with the snap ring pliers and install the planetary carrier assembly.
Check the installation by holding the case and carefully tapping the face of the input shaft against a
wooden block to make sure the snap ring is installed.
15. Remove all traces of gasket sealant from the front case and mounting adapter mating surfaces.
Advertisement
