Advertisement
11. Separate the front case from the rear case.
12. Remove all traces of gasket sealant from the mating surfaces of the front case and rear case.
13. If the speedometer drive gear is to be replaced, first remove the flange seal or use the Impact Slide
Hammer to pop off the flange seal.
Do not damage the bearing and the bearing case.
14. Remove the speedometer drive gear and upper tone wheel.
15. If the rear output shaft bearing requires replacing, remove the internal snap ring that retains the
bearing in the bore.
16. From the outside of the case, drive out the bearing.
17. Remove the three nuts and washers retaining the clutch coil assembly to the rear case.
18. Pull the coil assembly, along with the O-rings and wire, from the case.
Advertisement
