Advertisement
25. Remove the thrust washer from the output shaft.
26. Remove the oil pan magnet from the slot in the front of the case bottom.
27. Remove the output shaft and oil pump as an assembly.
28. If required, to remove the pump from the output shaft, rotate the pump to align.
29. Pull out the shift rail.
30. Remove the helical cam from the front case.
31. If required, remove the helical cam, torsion spring and sleeve from the shaft.
32. Remove the high-low range shift fork and collar as an assembly.
33. Expand the tangs of the large snap ring in the case using the Ring Plier or equivalent.
34. With the input shaft against a bench, push the case down and slide the main drive gear bearing
retainer off the bearing.
35. Lift the input shaft and front planet from the case.
36. If required, remove the oil seal from the case by prying and pulling on the curved-up lip of the oil seal
or use the Slide Hammer to pop off the oil seal.
37. Remove the internal snap ring from the planetary carrier.
38. Separate the front planet from the input shaft.
39. Remove the external snap ring from the input shaft.
40. Place the input shaft in a vise and remove the bearing.
41. Remove the thrust washer, thrust plate and the sun gear off the input shaft.
Advertisement
