Advertisement
REMOVAL
a. Never attempt to disassemble or repair the airbag module.
b. Do not drop the airbag module or allow contact with water, grease or oil. Replace
it if a dent, crack, deformation or rust are detected.
c. The airbag module should be stored on a flat surface and placed so that the pad
surface is facing upward. Do not place anything on top of it.
d. Do not expose the airbag module to temperature over 93°C (200°F)
e. An undeployed airbag module should only be disposed in accordance with the
procedures.
f. Never attempt to measure the circuit resistance of the airbag module (squib) even
if you are using the specified tester.If the circuit resistance is measured with a
tester, accidental airbag deployment will result in serious personal injury.
g. Whenever the PAB is deployed it should be replaced with a new one assembled
with an extension wire. The squib is melt down if the PAB is deployed making the
extension wire useless.
1. Disconnect the battery negative (-) terminal and remove the ignition key from the
vehicle.
Wait at least 30 seconds.
2. Remove the glove box. (Refer to the BD section.)
3. Disconnect the PAB module connector.
4. Remove the crash pad assembly and then undo the PAB module. (Refer to the BD
section)
5. Remove PAB module.
Advertisement
