Advertisement
5. If removed, position needle bearing and press into input shaft to dimension shown. Press in new sleeve
bearing to complete input shaft assembly.
6. Lift up gear carrier assembly and install input shaft assembly up through gear carrier assembly. Install
thrust washer and press bearing over end of input shaft assembly. Retain bearing on input shaft with
retaining ring in shaft groove.
7. If removed, press new pin into front adapter.
8. Position oil seal and press into front adapter to dimension shown.
9. Install snap ring in groove in front adapter with long ends of snap ring in adapter groove to complete
front adapter assembly.
10. Position front adapter assembly with face that mates with transfer case up. Support on wood blocks to
provide clearance for input shaft assembly. Position assembled input shaft and carrier group over
front adapter with input shaft down. Lower shaft and carrier group while expanding long ends of snap
ring until snap ring engages groove in outside diameter of bearing.
Advertisement
