Advertisement
1. Position cover on bed of suitable press so that open face of cover is up and parallel with press bed.
2. Position end of needle bearing with identification marking up and press into cover until upper end of
bearing is 1.593 - 1.603 in. (40.47 - 40.97 mm) below face of cover that mates with transfer case.
3. Press in ball bearing to bottom in cover and install snap ring.
4. On electric shift units only, install parts as follow :
(1) Verify that four O-rings (one on wire and one each on three studs) are in place on clutch coil
assembly. Install clutch coil assembly in inside of cover, with electrical wire and studs extending
through cover, with electrical wire and studs extending through cover. Use care not to kink or trap
electrical wire under clutch coil assembly. Attach with three nuts and torque to 6 - 8 lb·ft (8 - 11
Nm).
(2) Install motor bearing and oil seal in cover.
Advertisement
