17.4
Adding engine oil
Info
Too little engine oil or poor-quality engine oil will result in premature wear of the engine.
SERVICE WORK ON THE ENGINE 17
–
Lay the motorcycle on its side and fill the oil filter housing to
about ⅓ full with engine oil.
–
Fill the oil filter with engine oil and position the oil filter in the
housing.
–
Oil the O-ring of the oil filter cover and mount it together with
oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
V01397-11
–
Stand the motorcycle upright.
–
Remove filler plug
oil.
Engine oil
Info
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
401955-12
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the engine oil level. (
Main work
–
Remove filler plug
–
Add the same engine oil used when the last oil change was
carried out.
Engine oil (SAE 10W/50) (
401955-10
7
.
M6
10 Nm (7.4 lbf ft)
8
with the O-ring, and fill up with engine
1.0 l (1.1 qt.)
Engine oil
(SAE 10W/50)
(
p. 124)
1
with the O-ring.
p. 146)
p. 146)
127