17
SERVICE WORK ON THE ENGINE
17.4
Adding engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.
–
Remove screws
S00475-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
S00476-10
–
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with engine
oil.
–
Fill the oil filter with engine oil and place it in the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
M00305-10
–
Remove the oil filler plug
engine oil.
Engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to the
engine.
–
Install and tighten the oil filler plug with O-ring.
B01917-10
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may
result in unconsciousness and/or death.
–
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the engine oil level. (
. Remove the oil filter cover with the O-ring.
out of the oil filter housing.
with the O-ring from the clutch cover and fill up with
1.10 l (1.16 qt.)
When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effec-
tive exhaust extraction system.
p. 78)
M6
10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
80
.
p. 93)