Set-Gapping - Cisco Signaling Interface H.323 User Manual

set-gapping

set-gapping
The set-gapping command sets the type of calls to be gapped.
Syntax Description
inc
otg
both
normal
all
number
Usage Guidelines
If call gapping is set to 100 percent, all calls are gapped irrespective of the normal or all parameter
setting.
If the overload condition is active and call gapping is active, the higher of the two percentage values
determines whether new call attempts are accepted or rejected.
Examples
In the following example, the command sets all calls to be gapped and specifies that 50 percent of the
calls be rejected due to call gapping:
gw mml> set-gapping:both:calltype=all,percent=50
H323 Signaling Interface Day Mon 1 hh:mm:ss YYYY
M SUCC
Successfully set gapping for target 'both', calltype 'all', and percentage 50
Related Commands Command
rtrv-gapping
Cisco H.323 Signaling Interface User Guide
A-34
set-gapping: inc | otg | both : calltype=normal | all, percent=number
Gaps calls from the H.323 network.
Gaps calls from the PSTN over E-ISUP.
Gaps calls originating from either side.
Gaps all calls except priority and emergency calls.
Gaps calls of all types.
Specifies the percentage of calls rejected due to call gapping.
Description
Retrieves information about overload-triggered call gapping.
Appendix A MML User Interface and Command Reference
OL-4806-01 Rev. A14