Nonprovisionable Data; Mml Provisionable Data; H.323 System Parameters; Q.931 Parameters - Cisco Signaling Interface H.323 User Manual

Chapter 3 Provisioning the Cisco HSI

Nonprovisionable Data

The parameters in
Table 3-5
H323_SYS
system.manualstart
system.pdlname
system.delimiter
ras.gatekeeper
ras.rasmulticastaddress
h245.capabilities.manualoperation
h245.masterslave.manualoperation
q931.manualaccept
q931.earlyH245
q931.autoanswer
q931.manualcallprocessing
q931.h245tunneling

MML Provisionable Data

H.323 System Parameters

The parameters in
Table
Stop and restart the application for these changes to take effect.
The asterisk (*) after a parameter name in the first column of
Note
parameter that has an inbuilt default value if a value is not set in provisioning.
Table 3-6 H.323 System Initialization Parameters
Parameter Description
maxCalls* Maximum number of concurrent calls allowed
maxChannels* Maximum number of concurrent channels allowed

Q.931 Parameters

To modify the parameters listed in
prov-dlt, and prov-ed commands.
In the following example, the prov-add command sets the Q.931 parameter maxCalls to the value 2000.
OL-4806-01 Rev. A14
Table 3-5 cannot be altered through MML commands.
Nonprovisionable Data Parameters
Table 3-6 are required for H.323 stack initialization. To modify the parameters in
3-6, use the h323_sys MML name variable for the prov-add, prov-dlt, and prov-ed commands.
Description
Present
Absent
#FF
Absent
224.0.1.41.1718
Present
Present
Present
Present
Present
Present
Present
Table 3-6
Type
INTEGER(0, 65535)
INTEGER(0, 65535)
Table 3-7, use the q931 MML name variable for the prov-add,
Cisco H.323 Signaling Interface User Guide
H.323 Stack Configuration
denotes a mandatory RADVision
Example
2500
2
3-11