Ras Parameters - Cisco Signaling Interface H.323 User Manual

H.323 signaling interface
Table of Contents

Advertisement

Chapter 3
Provisioning the Cisco HSI

RAS Parameters

The parameters in
use the ras MML name variable for the prov-add, prov-dlt, and prov-ed commands.
In the following example, the prov-add command sets the RAS parameter maxfail to the value 3.
Example
prov-add:name=ras,maxfail=3
The array index [i] in some of the parameter names in the first column of
with a valid braced index from 1 to 20, and must be continuous and unique (that is, it must contain no
duplicates).
The Update Type column in
modified:
Immediate and next call update types are dynamic system data.
Note
The RAS parameter overlappedSending is not available here because it has been combined with the
Note
Q.931 overlappedSending parameter. If you set the Q.931 overlappedSending parameter, you also set the
the RAS overlappedSending parameter.
The asterisk (*) after a parameter name in the first column of
Note
parameter with an inbuilt default value that will be used if the value is not set in provisioning.
Table 3-8
RAS Parameters
Parameter Name
manualRAS
responseTimeOut*
maxFail*
OL-4806-01 Rev. A14
Table 3-8
are required for RAS stack initialization. To modify the RAS parameters,
Table 3-8
Immediate means that the effect of the change is immediate.
Start means that the application needs to be restarted for the change to take effect.
Next Call means that the next call has the new parameter set.
Description
If this parameter is present,
the stack does not perform
automatic RAS procedures
(it waits to be driven by the
application).
The time (in seconds) that
the stack waits until it
notifies the application that
the called party has failed to
respond to a transaction.
Maximum number of retry
gatekeeper registration
attempts.
shows when the change to a parameter takes effect after it is
Table 3-8
Type
NULL
INTEGER(1, 200)
INTEGER(1, 200)
Cisco H.323 Signaling Interface User Guide
H.323 Stack Configuration
Table 3-8
must be replaced
denotes a mandatory RADVision
Example
Update Type
Start
10
Immediate
3
Immediate
3-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hsi 4.1

Table of Contents