Error Messages; Mml Help; Quitting An Mml Session - Cisco Signaling Interface H.323 User Manual

MML Help

Error Messages

If an MML command does not perform, an error message is displayed.
messages and their descriptions.
.
Table A-4
Error Message
DENY
ICNV
IDNV
IISP
IITA
IPRM
SABT
SNVS
SNSP
SROF
MML Help
MML has an online help feature. The MML help command displays a list of valid system commands
and an explanation of each command's use. To display the online help, start an MML session and type
help at the command line prompt. See the

Quitting an MML Session

To quit an MML session, type quit at the prompt.
Cisco H.323 Signaling Interface User Guide
A-6
MML Error Messages and Descriptions
Definition
Command denied
Input command not valid
Input data not valid
Input syntax error
Invalid target
Input parameter missing
Status abort
Component not in valid state The requested operation failed because the
State not supported
Status requested operation
failed
Appendix A MML User Interface and Command Reference
Description
The system recognizes the command but does not
perform the requested function.
The system does not recognize the MML
command.
An unknown parameter was entered.
Incorrect syntax was entered.
The system cannot perform the requested
operation on the specified component, or the
component does not exist.
An expected parameter was not entered.
The requested operation did not complete within
the allotted time.
component is either not configured to accept the
operation or the component is already in the
desired state.
The operation is not supported by the component.
The requested operation failed.
"help" section on page A-11.
Table A-4 lists the MML error
OL-4806-01 Rev. A14