Sta-Trc - Cisco Signaling Interface H.323 User Manual

sta-trc

Related Commands Command
sta-callproc
sta-trc
The sta-trc command starts the call processing tracing function.
Syntax Description Calltype=calltype
TraceLevel=trace level
CdAddress=address
CgAddress=address
log=filename
prd=n
Defaults The default trace for all calls is 30 minutes.
Usage Guidelines Only one trace command at a time can be active. If an additional request is issued, the command is
rejected with a call trace already active indication.
Cisco H.323 Signaling Interface User Guide
A-38
Description
Starts call processing
sta-trc:Calltype=calltype,TraceLevel=trace level[,CdAddress=address]
[,CgAddress=address],log=filename[,prd=n]
This parameter defines the type of call to be traced. The possible values are:
•
•
•
This parameter defines the level of detail that is recorded in the call trace.
The possible values are:
•
•
•
A filter used to trace calls using only the specified leading digits within the
called address. A match is performed on these digits and the initial called
address digits contained within the E-ISUP IAM message or the H225
SETUP message.
A filter used to trace calls using only the specified leading digits within the
calling address. A match is performed on these digits and the initial calling
address digits contained within the E-ISUP IAM message or the H.225
SETUP message.
The filename for the trace output.
The trace period (in seconds). At expiration of this period, the trace log is
closed. If no value is specified, the period defaults to 1800 seconds (30
minutes).
Appendix A
inc—For H.323-originated calls
otg—For E-ISUP-originated calls
both—For calls originating from either side
terse—Traces only incoming/outgoing message names and RADvision
API calls.
brief—In addition to terse, traces internal interfaces, and call state
changes.
verbose—Traces all messages and their contents, RADvision API calls
and their contents, internal interfaces, and call state changes.
MML User Interface and Command Reference
OL-4806-01 Rev. A14