Prov-Sta - Cisco Signaling Interface H.323 User Manual

prov-sta

prov-sta
The prov-sta command establishes a provisioning session. The data files are copied from the source
version to the destination version.
Syntax Description srcver=version
dstver=version
Usage Guidelines If the source and destination filenames are the same, the new configuration overwrites the old
configuration. It is a good practice to copy an existing configuration instead of overwriting it so that you
can return to a known configuration if there are problems with the new one.
If the source provisioning session has not been verified, the message "Note: This provisioning session
has not been verified" is displayed, but the session starts normally.
If you try to start with a provisioning session that does not exist, an error is displayed, along with a list
of available sessions.
Examples
The MML command in the following example starts a provisioning session named nowt and creates a
new configuration named blah:
gw mml> prov-sta::srcver=nowt,dstver=blah
H323 Signaling Interface Sun Jan 7 13:32:07 2000
M DENY
The provisioning session called "nowt" does not exist.
The following configurations are available:
sanfran2 uk9 final
telco mgcpvia miki
transit dave matt
The MML command in the following example starts a provisioning session and creates a new
configuration named ver1:
gw mml> PROV-STA::SRCVER="new", DSTVER="ver1"
H323 Signaling Interface Sun Jan 7 13:32:07 2001
M SUCC
Successfully started provisioning session "ver1" from "new".
The MML command in the following example starts a provisioning session, opens the existing
configuration named ver1, and overwrites that configuration:
gw mml> PROV-STA::SRCVER="ver1", DSTVER="ver1"
Cisco H.323 Signaling Interface User Guide
A-20
prov-sta::srcver=version,dstver=version
Selects a specific configuration version as the source for configuration
changes. The srcver variable represents a directory that exists in
$GWBASE/var/prov/. In place of the configuration version, you can also
enter:
•
•
Specifies the output version directory for the configuration session results.
The dstver variable represents a directory stored in $GWBASE/var/prov/.
Appendix A
new—Specifies a new default session configuration; no existing source
configuration is used.
active—Selects the active configuration as the source for configuration
changes.
MML User Interface and Command Reference
OL-4806-01 Rev. A14