Cisco Signaling Interface H.323 User Manual page 61

Chapter 3 Provisioning the Cisco HSI
Table 3-14 Common Static System Data Parameters (continued)
Parameter Name
NotifyMsgEnabled
VSCB_IPADDR1/2
VSCB_PORT_NUMBER1/2 Port number, for example: 8003
The following MML command example shows the command sequence used to provision the static
system data parameters provided in the preceding table.
Example
mml
> prov-sta::srcver=active, dstver=myconf
> prov-ed:name=SYS_CONFIG_STATIC, DtmfSupportedType="dtmf"
> prov-cpy
> restart-softw
Table 3-15
Table 3-15 Common RAS Parameters
Parameter Name
gateway.prefix[1]
gateway.prefix[2]
timeToLive
The following MML command example shows the command sequence used to provision the RAS
parameters provided in the preceding table.
Example
mml
> prov-sta::srcver=active, dstver=myconf
> prov-ed:name=RAS, timeToLive=45
> prov-cpy
> restart-softw
OL-4806-01 Rev. A14
Parameter Values
For example:
"enabled"—a string that indicates the
•
feature is enabled.
Blank ("")—indicates the feature is
•
disabled
"deleted"—indicates that the feature
•
is disabled
IP address, for example: "10.10.10.1"
presents common RAS parameters.
Parameter Value
For example: 020
Integer (to specify number of seconds)
for example, 45
To enable lightweight RRQs, the
Note
value for this parameter should be
set substantially lower than the
default (600).
Description
Allows transit of connected number, display
information, and generic notification indicator in
H.225 Notify messages.
Allows IP address configuration of second PGW.
Allows port configuration of second PGW.
Description
HSI prefix (for gatekeeper registration)
RAS registration time to live.
See Table 3-8.
Cisco H.323 Signaling Interface User Guide
H.323 Stack Configuration
3-21