Introduction; Restarting The Cisco Hsi Application; Stopping Call Processing - Cisco Signaling Interface H.323 User Manual

Managing the Cisco HSI

Introduction

This chapter provides information about operation and management tasks for the Cisco H.323 Signaling
Interface (HSI) application. This chapter contains the following sections:
•
•
•
•
•
•
•
•
•
•

Restarting the Cisco HSI Application

To restart the Cisco HSI at the MML command prompt, use the restart-softw MML command. For more
information about this command, see
To start the Cisco HSI application, see the

Stopping Call Processing

To stop call processing, use the stp-callproc MML command. This command causes the handling of new
call requests to cease immediately, and, if no timeout period is specified, all existing calls are released
immediately. If a timeout period is specified, existing calls are released after the specified amount of
time has elapsed. For more information about the stp-callproc command, see
Interface and Command Reference."
OL-4806-01 Rev. A14
Restarting the Cisco HSI Application, page 4-1
Stopping Call Processing, page 4-1
Starting Call Processing, page 4-2
Stopping the Call Processing Application, page 4-2
Starting the Call Processing Application, page 4-2
Reporting the Cisco HSI Status, page 4-2
Measurements, page 4-2
Overload, page 4-6
Logging, page 4-9
Gapping, page 4-11
C H A P T E R
Appendix A, "MML User Interface and Command Reference."
"Installing the Cisco HSI" section on page
Cisco H.323 Signaling Interface User Guide
4
2-2.
Appendix A, "MML User
4-1