Cisco Signaling Interface H.323 User Manual page 45

Chapter 3 Provisioning the Cisco HSI
Table 3-3 Static System Data Parameters
Parameter
HOST_PORT_NUMBER1
HOST_PORT_NUMBER2
VSCA_IPADDR1
VSCA_IPADDR2
VSCB_IPADDR1
VSCB_IPADDR2
VSCA_PORT_NUMBER1
VSCA_PORT_NUMBER2
VSCB_PORT_NUMBER1
VSCB_PORT_NUMBER2
ClipClirSupported
RaiSupported
DtmfSupportedDirection
DtmfSupportedType
H225PavoSupported
PavoRedirScreeningInd
PavoRedirReason
OL-4806-01 Rev. A14
Type Description
[0-65535] The first port number to be used by the Cisco HSI. The default value is 0.
This value must match the peer port setting on the PGW
Note
E-ISUP IPLNK object.
[0-65535] The second port number to be used by the Cisco HSI. The default value is 0.
This value should always be set to 0.
Note
STRING The primary IP address of the primary PGW 2200.
STRING The secondary IP address of the primary PGW 2200.
This value must match that of VSCA_IPADDR1.
Note
STRING The primary IP address of the secondary PGW 2200.
This parameter is not used in a standalone PGW configuration.
Note
STRING The secondary IP address of the secondary PGW 2200.
The value of this parameter must match that of VSCB_IPADDR1.
Note
This parameter is not used in a standalone PGW configuration.
[0-65535] The first port number of the primary PGW 2200.
[0-65535] The second port number of the primary PGW 2200.
This value must match that of VSCA_PORT_NUMBER1.
Note
[0-65535] The first port number of the secondary PGW 2200.
This parameter is not used in a standalone PGW configuration.
Note
[0-65535] The second port number of the secondary PGW 2200.
The value of this parameter must match that of
Note
VSCA_PORT_NUMBER2. This parameter is not used in a
standalone PGW configuration.
STRING CLI Presentation or restriction is enabled if this parameter is present and set to
anything other than "". For example, to enable CLIP/CLIR support, set this
parameter explicitly to "Enabled."
STRING RAI support is enabled if this parameter is present and set to anything other than
"". For example, to enable RAI support, set this parameter to "Enabled."
STRING This is set to "both", "tx," or "rx". If this parameter is not present or is set to any
value other than "both," "tx," or "rx," the DTMF Relay feature is disabled.
STRING This is set to "dtmf" or "basicString." If this parameter is not present or set to
any other value, the DTMF Relay feature is disabled.
STRING Pavo support is enabled if this parameter is present and set to anything other than
"". For example, set it to "Enabled."
[0-3] The value of the Pavo redirecting number screening indicator. (If this parameter
is not provisioned, the default is Q.931 zero—user provided, not screened.)
[0-15] The value of the Pavo redirecting number reason field. This parameter has no
default. If unprovisioned, the redirecting number parameter will not contain the
Reason for Redirection field (octet 3b).
Cisco HSI Configuration
Cisco H.323 Signaling Interface User Guide
1
2200
3-5