Table of Contents
Advertisement
6
Number plate light
⇒ "6.1 Removing and installing number plate light X4 / X5 ", page
93
⇒ "6.2 Removing and installing bulb for number plate light X4 / X5
", page 93
6.1
Removing and installing number plate
light - X4- / -X5-
Note
When removing and installing components that are in view
(switches, covers, trim and so on), mask off areas in which tools
( assembly wedge - T10039/1- , screwdriver) are used to lever out
those components using commercially available masking tape.
Removing
– Switch off ignition and all electrical consumers, and withdraw
ignition key.
– Lever left-hand side of number plate light -arrow- out of bump‐
er cover, using a screwdriver.
– Pull number plate light out of bumper cover, taking connected
wire lengths into account.
– Turn bulb holder -1- in -direction of arrow- and pull out.
– Remove number plate light.
Installing
Install in the reverse order of removal observing the following:
– Insert number plate light into bumper cover, starting at
right.hand side, and then push it in on the left-hand side, mak‐
ing sure it is latched in place securely.
– Check function of number plate light.
6.2
Removing and installing bulb for number
plate light - X4- / -X5-
Removing
– Switch off ignition and all electrical consumers, and withdraw
ignition key.
– Remove number plate light - X-
⇒ page 93
.
Electrical system - Edition 03.2017
6. Number plate light
up! 2012 ➤
93
Advertisement
Table of Contents
