Removing And Installing Ignition Key Withdrawal Lock Solenoid N376 - Volkswagen up! 2012 Workshop Manual

up! 2012 ➤
Electrical system - Edition 03.2017
– Drill out shear heads -arrows- using an angle drill and an
8.5 mm drill bit.
– Remove steering lock housing from steering column.
The following components must be removed to renew the steering
lock housing:
♦ Ignition/starter switch - D-
♦ Lock cylinder ⇒ page 110
♦ Ignition key withdrawal lock solenoid - N376- (vehicles with
dual clutch gearbox)
Installing
Install in the reverse order of removal, observing the following:
– Tighten new bolts -arrows- until shear heads break off.
7.2.10 Removing and installing ignition key
withdrawal lock solenoid - N376-
Removing
– Remove lower steering column trim ⇒ General body repairs,
interior; Rep. gr. 68 ; Compartments and covers; Removing
and installing lower steering column trim .
WARNING
Risk of damage to the electronic components due to electro‐
static discharge.
♦ Before disconnecting the electrical connector, the me‐
chanic must electrostatically discharge himself or herself
by briefly grasping hold of door striker plate or similar.
– Disconnect connector -2- from ignition key withdrawal lock
solenoid - N376- -1-.
– Push retaining tab in -direction of arrow A-, and pull ignition
key withdrawal lock solenoid - N376- -1- in
-direction of arrow B- off steering lock housing -3-.
Installing
Install in the reverse order of removal, observing the following:
– Perform functional check.
114
Rep. gr.94 - Lights, bulbs, switches - exterior
⇒ page 110
⇒ page 114