Table of Contents
Advertisement
up! 2012 ➤
Electrical system - Edition 03.2017
– Release and pull off DF cable connector -4-.
– Undo nut -3- and detach B+ wire -2- from connection thread.
– Remove alternator - C- -1- by taking it upwards out of vehicle.
Installing
Install in the reverse order of removal observing the following:
Caution
♦ When fitting used poly V-belts, take note of the direction
of rotation as marked during removal!
♦ Before installing poly V-belt, ensure that all ancillaries (al‐
ternator, air conditioner compressor) are secure.
♦ When fitting belt, ensure that poly V-belt seats correctly in
pulleys!
– Drive threaded bushes -A- approx. 4 mm in direction of arrow
out of housing of alternator - C- .
– Connect battery
⇒ page 5
– Start engine and check belt running.
Specified torques
♦
⇒ "2.1 Assembly overview - alternator", page 10
2.2.2
Removing and installing alternator, nat‐
ural gas engine
Caution
To disconnect and reconnect the battery, the procedure de‐
scribed in the workshop manual should be strictly adhered to
⇒ page 5
.
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1331-
Removing
– Disconnect battery
⇒ page 5
12
Rep. gr.27 - Starter, current supply, CCS
.
.
Advertisement
Table of Contents
