Table of Contents
Advertisement
♦ Release tool set - VAS 1978/35-
Caution
To disconnect and reconnect the battery, the procedure de‐
scribed in the workshop manual should be strictly adhered to
⇒ page 5
.
Note
The illustrations show removal and installation of the relay
♦
carrier in an LHD vehicle.
Removal and installation of the relay carrier in an RHD vehicle
♦
are analogous.
Removing
– Switch off ignition and all electrical consumers, and withdraw
ignition key.
– Disconnect battery
⇒ page 5
– Remove trim in footwell ⇒ General body repairs, interior; Rep.
gr. 68 ; Storage compartments/covers; Fitting locations over‐
view - storage compartments/covers .
– Remove lower A-pillar trim on driver side ⇒ General body re‐
pairs, interior; Rep. gr. 70 ; Interior trims; Assembly overview
- A-pillar trim .
– Remove fuse holder from relay carrier
– Remove onboard supply control unit - J519-
Note
For reasons of clarity, the relay carrier is shown from the rear in
the following illustrations.
.
⇒ page 148
.
⇒ page 153
Electrical system - Edition 03.2017
.
1. Relay carriers, fuse holders, electronics boxes
up! 2012 ➤
151
Advertisement
Table of Contents
