Removing And Installing Steering Column Combination Switch E595 - Volkswagen up! 2012 Workshop Manual

up! 2012 ➤
Electrical system - Edition 03.2017
– Disconnect connector -2- on airbag coil connector and return
ring with slip ring - F138- -1-.
– Unscrew bolts -arrows- of airbag coil connector and return ring
with slip ring - F138- -1-.
– Remove airbag coil connector and return ring with slip ring -
F138- -1- from steering column combination switch - E595- .
Installing
Install in the reverse order of removal, observing the following:
Caution
Risk of damage to airbag coil connector and return ring with
slip ring - F138- .
♦ The airbag coil connector and return ring with slip ring -
F138- is always centred when delivered as a replacement
part.
♦ Do not change this setting.
– Check the following before installing airbag coil connector and
return ring with slip ring - F138- -1-:
• The airbag coil connector and return ring -2- must be visible
through the aperture.
Specified torques
♦ ⇒ "7.2.1 Assembly overview - steering column switch module",
page 103
7.2.3 Removing and installing steering col‐
umn combination switch - E595-
Depending on vehicle equipment, the following components are
integrated into the steering column combination switch - E595- as
one unit:
♦ Turn signal switch - E2-
♦ Headlight dipper and flasher switch - E4-
♦ Parking light switch - E19-
♦ Intermittent wiper switch - E22-
♦ Rear window wiper switch - E34-
♦ Intermittent wiper regulator - E38-
♦ Cruise control system switch - E45-
♦ Cruise control system (CCS) SET button - E227-
Note
If one of the components is defective, the steering column com‐
bination switch - E595- must be renewed as a complete unit.
106
Rep. gr.94 - Lights, bulbs, switches - exterior