SamplexPower EVO-RC-PLUS Owner's Manual page 9

SECTION 3 |
3.2 POWER ON / POWER OFF
i
INFO
a) Minimum battery voltage required for initiating MANUAL powering ON of EVO™ Series
Inverter/Chargers is given below:
b) EVO™ Series Inverter/Chargers will power ON automatically when the battery voltage and
AC input voltage are within the limits shown in the Table given below:
EVO-1212F/EVO-1212F-HW/
EVO-2212/ /EVO-3012
EVO-1224F/ EVO-1224F-HW/
EVO-2224/EVO-4024
EVO-2212E/EVO-3012E
EVO-2224E/EVO-4024E
EVO-4248SP
If the AC input voltage and frequency are within the programmed limits, the units will power
ON automatically and will start operating in "Charging Mode". If the AC input voltage and
frequency are not within the programmed limits, the units will power ON automatically and
will start operating in "Inverting Mode"
c) To power OFF the EVO™ Inverter/Chargers manually using the ON/OFF Button on the
front panel of the unit or the ON/OFF Key on the Remote-Control EVO-RC-PLUS, there
should be no AC input voltage or, has to be less than the limits shown in the Table
below. First, Switch OFF the AC input power to the unit and then, POWER OFF manually.
However, if a unit is in "Fault Mode" (Fault messages in Table 7.1, Section 7), it will be
possible to power OFF the unit manually with the help of ON/OFF Button on the front
panel of the unit or the ON/OFF Key on the Remote-Control EVO-RC-PLUS
EVO-1212F/EVO-1212F-HW/
EVO-2212/ /EVO-3012
EVO-1224F/ EVO-1224F-HW/
EVO-2224/EVO-4024
EVO-2212E/EVO-3012E
EVO-2224E/EVO-4024E
EVO-4248SP
Operation
12V Models: " Higher than 9V
•
24V Models: " Higher than 18V
•
48V Models: " Higher than 36V
•
Model No.
Model No.
Battery Voltage Limit to
Power ON Automatically
>12 VDC
>24 VDC
>12 VDC
>24 VDC
>36 VDC
AC Input Voltage Limit to Power ON Automatically
Line Voltage
< 140 VAC ± 3%
AC Input Voltage Limit to
Power ON Automatically
> 70 ± 5 VAC
> 140 ± 10 VAC
Line Voltage
> 170 VAC ± 5%
< 70 ± 5 VAC
< 140 ± 10 VAC
Phase Voltage
< 70 VAC ± 3%
SAMLEX AMERICA INC. | 9
Phase Voltage
> 85 VAC ± 5%