Table of Contents
Advertisement
SECTION 4 |
4.1.3.4 "Select Parameter" Menu Map for Parameter Group 6: RC-PLUS SETTING
S e l e c t
P a r a m e t e r
R C - P L U S
Screen
No. 1
*
A C T I V E
L C D
4 =
1 0 0
S e l e c t
P a r a m e t e r
R C - P L U S
Screen
No. 2
*
I D L E
L C D
1 =
S e l e c t
P a r a m e t e r
R C - P L U S
Screen
No. 3
*
I D L E
L C D
5
Fig 4.5 "Select Parameter" Menu Map for Parameter Group 6: RC-PLUS SETTING
4.1.3.5 "Select Parameter" Menu Maps for (i) Parameter Group 7: TIME SETTING and
(ii) Parameter Group 8: STOP SD CARD
NOTE:
Value shown in the 4th line of the display screen for Group 8, "STOP SD CARD" is the default / factory pre-set
value. For additional programming details, refer to (i) Section 4.10 for "TIME SETTING" and (ii) Section 4.11 for
STOP SD CARD"
4.2 PARAMETER SETUP PROCEDURE
4.2.1 General Information - Parameter Setup Procedure
Please refer to Fig 4.7.
The Enter key is used to enter "Select Group" Menu Map from any Operating Mode Screen shown in Figs 3.1 to 3.8
(See Table 3.1 under Section 3.6.1).
Example in Fig 4.7 starts with Inverting Mode Screen [Screen 1 in Figs 3.2(a), 3.2(b) and 3.3(b)]. After the Enter key is
pressed, the Up/Down keys are used to navigate to one of the 8 "Select Group" Screens (Fig 4.1). When the Group for
the desired setting is displayed on the LCD, the Enter Key is used again to select this Group. The Up and Down Keys
are used to move to the individual screens within the Group.
Pressing the Back Key will exit to the previous level.
44 | SAMLEX AMERICA INC.
Parameter Setup
S E T T I N G
L I G H T
%
S E T T I N G
L I G H T
2 5
%
S E T T I N G
T I
E R
M
m i n
Group 7
"TIME SETTING"
S e l e c t
P a r a m e t e r
T I
E
S E T T I N G
M
*
E n t e r
t h e
2 0 0 0 / 0 1 / 0 1
Fig 4.6 "Select Parameter" Menu Map for (i) Parameter Group 7:
TIME SETTING and (ii) Parameter Group 8: STOP SD CARD.
NOTES:
1. Value shown in the 4
/ factory pre-set values (EVO-1212F / 1212F-HW in this
case). For the default / factory pre-set values and additional
programming details for the other Models, refer to Table 4.10
(Section 4.9.1) for "RC-PLUS SETTING"
2. Asterisk sign * in the beginning of the 3
screen points that the parameter shown in this line will be se-
lected for further programming when the Enter Key is pressed
3. Use ñ and ò Keys to navigate to the desired screen.
Up Key
Down Key
S e l e c t
t i m e
0 0 : 0 0
line of the display screen is the default
th
Group 8
"STOP SD CARD"
P a r a m e t e r
S T O P
S D
C A R D
0 = N o
line of the display
rd
Advertisement
Table of Contents
