SamplexPower EVO-RC-PLUS Owner's Manual page 55

Remote control for evolution series inverter/ charger
Table of Contents

Advertisement

SECTION 4 |
4.4.2.4 FLOAT VOLTAGE (Table 4.3, Screen No. 4)
This sets the charging voltage in the Constant Voltage Float Stage.
4.4.2.4.1 Programming Steps for Parameter "FLOAT VOLTAGE"
Any Operating Mode Screen from
Fig 3.1 to 3.8
E V O - 1 2 1 2 F
I n v e r t i n g
A C
o u t p u t :
1 2 0 . 0 V
< 0 . 1 0 A
6 0 . 0 0 H z
[Above screen is Screen 1 of Fig 3.2(a)]
4.4.2.5 COMPENSATE (Table 4.3, Screen No. 5)
This parameter sets the temperature compensation for the battery. The operational range of the EVO™ Inverter/Charger
is -20°C to 60°C.
This compensation voltage will affect the Absorption Voltage/Equalize Voltage/Floating Voltage/Batt Over Volt/Restart
Voltage/Low Volt Alarm/Batt Low Voltage when the Temperature Sensor is installed on the battery (see Section 2.5 in
the Owner's Manual for Evolution™ Series Inverter/Charger).
!
CAUTIONS!
1. Lithium Ion charging does not require temperature compensation. Hence, do not use EVO-BCTS
Temperature Sensor when charging Lithium Ion Batteries.
2. Automatic temperature compensation using EVO-BCTS Temperature Sensor is designed for Lead
Acid Batteries based on programming parameter "COMPENSATE". When charging Nickel-Zinc
(Ni-Zn) batteries, ensure that the value of programming parameter "COMPENSATE" is set based
on approximate linear compensation for the particular Ni-Zn battery.
!
ATTENTIONS!
1. Le chargement au lithium-ion ne nécessite pas de compensation de température. Par
conséquent, n'utilisez pas le capteur de température EVO-BCTS lors du chargement de batteries
au lithium-ion.
2. Compensation automatique de la température à l'aide d'EVO-BCTS Capteur de température
est conçu pour les batteries au plomb basée sur la programmation paramètre "COMPENSATE".
Lorsque la charge des batteries Nickel-Zinc (Ni - Zn), s'assurer que la valeur du paramètre de
programmation "COMPENSATE" est déterminé en fonction du linéaire approximatif pour
l'indemnisation de la batterie Ni - Zn particulier.
Parameter Setup
Enter Key
S e l e c t
G r o u p
*
C H A R G E
C U R V E
ð
P a s s w o r d
k e y
0 0 0 0
Password 8052
See Section 4.3.1
Enter Key
S e l e c t
P a r a m e t e r
C H A R G E
ð
*
B U L K
C U R R E N T
2 0 A
Enter Key
S e l e c t
P a r a m e t e r
i n
C H A R G E
ð
*
F L O A T
V O L T A G E
1 3 . 5 0 V
See Table 4.3, Parameter Setup
Screen No. 4 for
programmable range
Down Key x 3 times
S e l e c t
C U R V E
C H A R G E
ð
*
F L O A T
C U R V E
SAMLEX AMERICA INC. | 55
Enter Key
P a r a m e t e r
C U R V E
ð
V O L T A G E
1 3 . 5 0 V

Advertisement

Table of Contents
loading

Table of Contents