Table of Contents
Advertisement
DSC 301 HD OSD Menu System — Configuration and Adjustments
Scaler configuration and adjustments can be performed by using the On-screen Display
(OSD) menu or the Extron SIS commands (see the
section, starting on page 22).
The OSD menu can be seen on the connected display device.
OSD Menu Navigation Using Front Panel Controls
Menu Overview
The OSD menu has nine configuration submenus, two of which are read-only information
pages.
Using each of the submenus, the video and audio inputs and the HDMI output of the
DSC 301 HD can be configured. In addition, you can save and recall the input
configuration as a user preset. The Advanced submenu allows you to choose a test
pattern to aid in the system setup and to set up a screen saver display when there are
no active input signals. Use the remote control port configuration to view the read-only
Communication submenu. Use the read-only Device Info screen to view device status
elements.
All submenu screens show the model name (DSC 301 HD) and firmware version in the
header, and the input and output resolution information in the footer.
NOTES:
To navigate and use the OSD menu:
1.
2.
3.
4.
5.
6.
7.
8.
NOTE: In any submenu, values that do not apply to the current input are shown as
•
Menu button — Press the Menu button (see
to activate or deactivate the main menu.
•
Enter button — Press the Enter button (
a selected main menu item and to exit and accept the setting.
({, [) knobs — In the menu configuration mode, rotate the
•
Adjust
horizontal ([) and vertical ({) Adjust knobs (
options and to make adjustment selections.
Input x refers to the selected input, for example, Input 2.
•
The Device Info menu and the Communication menu are read-only and give
•
current device status.
Press the Menu button (
) once to open the menu on the display. The menu opens
E
with the Quick Setup submenu (see
If the desired submenu is not showing, use the
) to navigate to the desired menu.
F
Press the
button to access the submenu (
Enter
Rotate either
knob to cycle through the submenu to the desired option.
Adjust
NOTE: Default values are indicated on the OSD by an asterisk (*).
Press the
button to access the submenu item.
Enter
Rotate either
knob to adjust the value as desired.
Adjust
Press
to accept the new value. Press it again if action confirmation is required.
Enter
Press
to exit the submenu. Press it again to exit and close the main menu.
Menu
N/A.
SIS Communication and Control
figure
3,
on the previous page)
E
) to move between the submenus of
E
) to scroll through submenu
F
figure 4
on the next page).
knobs ({, [) (see
Adjust
).
E
DSC 301 HD • Operation
figure
3,
9
Advertisement
Table of Contents
