Table of Contents
Advertisement
im Vertrieb von
Menus, Configuration, and Adjustments
Moving through menus by using front panel controls
Menu overview
Power
on
www.camboard.de
CAMBOARD Electronics
Scaler configuration and adjustments can be performed by using the embedded
Web pages and the Windows-based control program (see chapter 3, Serial
Communication for details) or by using the front panel controls and the menus
that are displayed on the
DVS 304's LCD screen. These menus are used primarily when the scaler is first
set up.
Menu button — Press the Menu button to activate menus and scroll through the
eight main menus.
Next button — Press the Next button to move between the submenus of a
selected main menu. Pressing the Next button during input configuration causes
the current input's number and format type to be displayed on the LCD
Adjust ( ,
) knobs — In configuration mode, rotate the Adjust horizontal (
knob and Adjust vertical ( ) knob to scroll through submenu options and to
make adjustment selections. Refer to the flowcharts in this chapter and to
specific sections for explanations on knob adjustments.
The default menus appear on the LCD when no adjustments are actively being
made. They cycle between the screen showing the model of the scaler (DVS 304
or DVS 304 A) and the screen that shows the active input's number and video
format, shown below.
EXTRON
FW version 1.00
DVS 304
2 sec.
Figure 2-8 — Default menus
From any menu or submenu, after 20 seconds of inactivity the DVS 304 will
save all adjustment settings and timeout to the default menus.
The main menus are shown on the following pages. Use the Menu button to
scroll between them.
If no signal is present on the currently selected input, NO SIGNAL will
appear in place of a signal value.
Tel. 07131 911201
Fax 07131 911203
2 sec.
60-736-01
INPUT 1
COMPOSITE
2 sec.
ce-info@camboard.de
DVS 304 • Installation and Operation
)
Default Cycle
2 sec.
OUTPUT
1024 x 768@60
2 sec.
2- 9
Advertisement
Table of Contents
