Table of Contents
Advertisement
Input submenu
This submenu allows you to configure the active input (see figure 7).
1
2
3
4
5
6
7
8
Figure 7.
OSD Menu — Input Submenu
Auto-Image — Select this (
Input x: Input Format — Select this (
NOTE: Only input 2 can be changed (RGB or YUV). Input 1 is always composite video
and input 3 is always HDMI.
Input x: Film Mode — Select this (
(Pixel) Start — Select this (
to +255, default is 128).
(pixels) — Select this (
Active
is dependant on input).
Total Pixels and Phase — Select this (
phase value for RGB and YUV input signals.
Input x: HDCP Authorized — Select this (
or off.
NOTE: Applies to HDMI input 3 only.
When disabled (off) the DSC 301 HD does not display content that requires HDCP, and
displays ether a blank screen or a warning message from the input source.
Input x: EDID — Select this (
RGB, DVI or HDMI inputs. Set to either match output rate, or a custom user-defined
EDID, or a factory setting (see
EDID data).
) to start a one-time Auto-Image on the active input.
1
) to change the active input format.
2
) to turn film mode on (auto detect mode) or off.
3
) to adjust the horizontal and vertical pixel start (range is 0
4
) to adjust the horizontal and vertical active pixels (range
5
) to set the number of active pixels and the
6
) to turn the HDCP Authorized on (default)
7
) to change the EDID (resolution and refresh rate) for
8
Resolutions and Refresh Rates table
on page 20 for
DSC 301 HD • Operation
13
Advertisement
Table of Contents
