Table of Contents
Advertisement
To set the Front Panel Lockout mode, click the applicable Front Panel Lockout
(Exec Mode) radio button as desired (see
•
Unlock front panel.
•
Mode 1: Lock front panel.
•
Mode 2: Limit front panel to input selection.
To enable Auto Switch, check the Auto Switch checkbox (
applicable radio button.
•
Priority to the highest active input number
•
Priority to the lowest active input number
To disable auto input selection, uncheck the Auto Switch checkbox.
To set HDCP Mode, click the desired radio button (
•
Follow Input — Encrypts the output only when required by the selected input
source.
•
Always Encrypt Output — Always encrypts the output, regardless of the HDCP
status of the selected input source.
•
Follow Input (with continuous DVI trials) — Encrypts the output only when
required by the selected input source. Use this setting when DVI sink devices initially
pass HDCP encrypted content, but intermittently display a green HDCP notification
screen after a power cycle or resuming from sleep mode.
Always Encrypt Output (with continuous DVI trials) — Always
•
encrypts the output regardless of the HDCP status of the selected input source.
Use this setting when DVI sink devices initially pass HDCP encrypted content,
but intermittently display a green HDCP notification screen after a power cycle or
resuming from sleep mode.
figure
49,
, on the previous page).
5
6
) as desired, from:
7
DSC 301 HD • Product Configuration Software
) and then click the
64
Advertisement
Table of Contents
