Table of Contents
Advertisement
Signal Sampling panel
Signal sampling optimizes the input signal to the scaler for the currently selected input
(see
figure
41,
on the previous page).
1
2
3
4
Figure 42.
Signal Sampling Panel
To manually adjust signal sampling settings, enter a value within the Min and Max values
displayed to the right of each adjustable setting, or click the Up or Down arrows (see
figure 42,
). An asterisk beside a chosen value for a signal sampling setting indicates
1
that it is a default value for the applied video signal.
To automatically adjust these settings, perform one of the following:
•
Click the Auto-Image button (
Click the Auto-Image & Fill button (
•
the entire video output (ignores aspect ratio setting).
Click the Auto-Image & Follow button (
•
to maintain the aspect ratio of the input signal (ignores aspect ratio setting).
Picture Controls panel
The Picture Controls panel shows adjustable image settings for the selected input
(see
figure
41,
, on the previous page).
2
1
Figure 43.
Picture Controls Panel
To adjust the picture settings, click and drag the associated slider for any image setting
(brightness, contrast, color, tint, or detail) to the desired value (see figure 43,
Alternatively, enter a value within the field associated with the image setting, or click the
and Down arrows (
) to change the value in the field.
Up
2
Overscan
Overscan is specific to each input signal type (see
zooms and crops SMPTE inputs to mask edge effects and ancillary data that are common
in broadcast signals.
Issuing an Auto-Image with overscan enabled, runs an Auto Phase routine (YUV and RGB
only) and centers and sizes the input according to table values.
1
) to perform a one-time Auto-Image.
2
) to perform a one-time Auto-Image and fill
3
) to perform a one-time Auto-Image and
4
2
figure 44
DSC 301 HD • Product Configuration Software
).
1
on the next page). This mode
57
Advertisement
Table of Contents
