Balanced Body Contrology Reformer Manual page 6

7. Attach the Storage Chain (shortest chain) to the middle eye
bolt on the top cross tube using the Quick Link.
8. Attach the Safety Chains, one to each of the outer eye bolts
on the top cross tube using the Quick Links.
9. Attach the Push Through Bar Spring with the quick link to one
of the top tube outer eye bolts. The other (2) Push Through
Bar springs will connect to the reformer frame eye bolts using
the open hooks. See Figure 16 for reference.
ASSEMBLY MAT CONVERSION
1. You will need to install legs on your Mat Conversion pad
before using.
2. Find the (4) feet with a thread sticking out and thread them into
the corner inserts on the bottom side of the mat conversion.
3. Turn them clockwise until tight. Hand tight is okay.
See Figure 17.
6
Figure 17
Quick Link
Closed hooks both ends
1 open hook (left) and 1 closed hook (right)
D)
E) F)
INSTALLING THE MAT CONVERSION
1. Remove all springs that are attached to the spring bar.
2. Remove the shoulder pads and brackets from the carriage.
3. Roll the carriage to the head end of the frame. When close to
the end of the frame, drop in the Mat Caster Cover assembly
between the frame and the carriage. This will act as a stopper
for the carriage and cover the casters. See Figure 18. The flaps
go over shoulder plates, when the shoulder rests are removed.
Double
Harness Snaps
Figure 16: D) Push Through Bar Springs
E) Quick link
F) Double harness snap
Figure 18