Balanced Body Contrology Reformer Manual page 4

INSTALL THE OPTIONAL JUMPBOARD
(86"/218cm and 89"/226cm models only)
Correct installation of the jumpboard is very important. Lay the
footbar flat down on the Reformer. Install the jumpboard down
into the installed bracket on the inside of the foot end of the
Reformer. The padded side should face the carriage. Properly
installed the jumpboard will rest on the foot plate bracket, see
Figure 12.
Figure 12
FIXED STRAP HOOK (OPTIONAL)
Figure 13
LEVELING
If desired or needed, there are (4) square pads that can be placed
one under each leg; if your machine is not sitting level on your
floor, or if the machine is moving during use.
4
This Reformer comes with an
option to install a Fixed Hook
for the straps. This can be
installed as shown in Figure
13. Non-Adjustable Strap Kit
(210-146). If your machine
came with a Fixed Strap
Hook pre-installed, it may
be removed and a Kit for
Adjustable Straps (210-145)
may be purchased separately.