Operating The System; Change Day/Night Mode; Bypassing A Device; Bypassing A Zone - INIM Electronics SmartLoop Programming Manual

Operating the system

Only persons responsible for the safety of the building and its occupants (Level 2) can operate the
system after entering a code or inserting the key in the keyswitch.
These operators can access the functions described in this chapter.
28.1

Change Day/Night mode

FROM COMPUTER
Not available.
This option will allow operators to change the Day/Night operating mode manually.
FROM PANEL
<any key>,
or <any key>,
pa nel in Mod e :
Note:
For automatic control of the Day/Night mode function, ypu must set up a timer.
28.2

Bypassing a device

FROM COMPUTER
Not available.
Under certain circumstances (e.g. maintenance or fault conditions), it may be necessary to bypass a
zone or a point. Bypassed zones or points cannot generate fault or alarm signals and cannot be
activated.
FROM PANEL
<any key>,
or <any key>,
Po int x/y yy <Dev.
< Device Typ e >
S TATUS :
= Select Po int
28.3

Bypassing a zone

FROM COMPUTER
Not available.
During maintenance or fault status, it may become necessary to bypass a zone. Bypassed zones
cannot generate faults, alarms or signals and cannot be activated.
70
3 Panel Settings, <code>, panel in Mode,
3 <code> /
_ay
4 Disable, <code>, 1 Loop devices, x Loop x, yyy point,
4 <code> 1 x yyy
De scription>
_ nabled
= Enable/Dis able
Chapter 28
Press keys and
function mode.
Press ESC to confirm and step back to
the previous menu.
Operating the system
Programming Manual
to change the