INIM Electronics SmartLoop Programming Manual page 69

Programming Manual
27.7.1 Loop diagnostic parameters
Detectors, IN Modules, OUT
Modules, Sounders, Call Points
Average loop contamination
MAX contamination level
on detector
Average loop signal deterioration
MAX signal deterioration
on point
Report Printout
Press to view the list of devices:
001 <Dev . Type>
002 <Dev . T ype>
003 <Dev . T ype>
004 <Dev . T ype>
Point 1/ 001 <Dev. Descript ion>
Type :
S moke: ---
S ensibility :
Note:
The parameters depend on the type of device installed, refer to the device instructions for details.
Maintenance operations
This is the total of the devices connected to the loop, arranged in
categories.
This is average contamination level calculated on all the detectors
of the same type.
This is maximum percentage of contamination found on the
detector concerned.
This is average percentage of signal deterioration calculated on all
the loop detectors.
This is maximum percentage of deterioration found on the detector
concerned.
Press the
configured loops and devices (with addresses other than "255").
<Dev. Descript ion>
< Dev. Descript ion>
< Dev. Descript ion>
< Dev. Descript ion>
<D ev. T ype>
---
key on this option, to printout the data relating to the
Press keys
or type in the device number.
Press to view the device parameters.
Press keys
the parameters.
Press keys
the devices.
and to scroll the devices,
and to navigate through
and to navigate through
69