Initializing Configuration/Programming From A Remote Location - INIM Electronics SmartLoop Programming Manual

Hide thumbs Also See for SmartLoop:

Table of Contents

Programming Manual

Chapter 9

Initializing configuration/programming from a remote location

Configuration/programming and maintenance operations can be done by the installer and authorized

technicians only (Level 3), who must have previously:

1. connected the programming jumper J2 PROGRAM;

2. set up the SmartLAN board for Internet access.

Then, after connecting to Internet can:

1. access the Internet browser and enter the IP address of the control panel;

2. enter the Access Code.

Note:

Refer to Chapter 23 - Setting up the Internet network.

Initializing configuration/programming from a remote location

Table of Contents

Do you have a question about the SmartLoop and is the answer not in the manual?