Restoring To Factory Default Settings - INIM Electronics SmartLoop Programming Manual

Programming Manual
7.2.5 Auto-Enrolling local I/O expansion boards and telephone dialler board
(SmartLoop\INOUT and SmartLoop\PSTN)
FROM PANEL
<any key>,
or <any key>,
If a telephone dialler board (SmartLoop\PSTN) and/or I/O expansion boards (SmartLoop\INOUT) are
connected, the control panel will recognize their presence.
Note:
To delete the telephone dialler board from the configuration, simply disconnect it and select the
Optional Cards option.
Op tional Car ds Found
I /O Expansi on
SmartLoop/PSTN
7.2.6 Auto-configuring the entire system (Complete)
FROM PANEL
<any key>,
or <any key>,
This function enrolls the system devices in the following order: Loops, Repeaters, Network and I/O
expansion and Telephone dialler boards. It presents the screens used for the manual procedure
(described in the previous paragraphs) and requests confirmation to start the process.
Yo u selected to autoco nfigure
l oops n , repeater s,
Ne twork Addres s
CO NTINUE? E nter=YES
Note:
This procedure make take several minutes. A progress bar will indicate the advancement of each
phase.
7.3

Restoring to factory default settings

FROM PANEL
<any key>,
or <any key>,
If you wish to change the configuration radically, you should re-initialize the control
operation restores the control panel to factory default settings (no configuration, all network devices
at address '0').
Note:
Restoral of factory default settings is the only method that ensures total data re-initialization.
Creating a new software solution and re-uploading the control panel does not guarantee total data
re-initialization.
Initialising the configuration/programming from panel
8 Programming, <code>, 1 Configuration, 2 Modify
Configuration, 1 AUTO Configuration , 5 Optional Cards,
8 <code> 1 2 1 5
:
8 Programming, <code>, 1 Configuration, 2 Modify
Configuration, 1 AUTO Configuration, 1 Complete,
8<code> 1 2 1 1
:
nn, I/O ex
Esc=NO
8 Programming, <code>, 1 Configuration,
3 Factory default restore,
8 <code> 1 3
"I/O Expansion" and "SmartLoop/PSTN
board" appears only when the boards are
seen by the control panel.
Press key to confirm and start the
AUTO Configuration Complete process.
panel. This
21