Viewing The Control Panel Configuration - INIM Electronics SmartLoop Programming Manual

Pa nel will b e restored to factory
de fault and a ll pr ogrammed data will be
de leted !!!
CO NTINUE? E nter=YES
7.4

Viewing the control panel configuration

It is possible to view the control panel configuration at all times.
7.4.1 Viewing the loop configuration data
FROM PANEL
<any key>,
or <any key>,
Lo op n. x
De tectors
OU T Module
So unders
7.4.2 View the control panels in the network
FROM PANEL
<any key>,
or <any key>,
It is possible to view the status/data of the control panels adjacent to the one you are working on, and
the control panels in the network, whether "In Service" or "Out-of-order" (due to connection faults).
Note:
The list excludes any control panels that are not cofigured (i.e. Address '0').
Pa nel Networ k Address
pa nel connec ted on POR T
pa nel connec ted on POR T
Pr ess Enter For Config uration Vie w
0
AD D : 12345 6789012345 67890123456 7890
CO NF : x
FA ULT:
7.4.3 Viewing the Repeaters on the RS485 BUS
FROM PANEL
<any key>,
or <any key>,
Note:
The description will appear only when the Repeater is properly enrolled in the configuration.
22
Esc=NO
8 Programming, <code>, 1 Configuration, 1 View
Configuration, 1 Loop,
8 <code> 1 1 1
<Loop Descript ion>
:xxx IN Module
:xxx IN/OUT Mod.
:xxx Call Poin ts
8 Programming, <code>, 1 Configuration, 1 View
configuration, 2 Network,
8 <code> 1 1 2
A : a a
B : b b
1 2
xxx
x
8 Programming, <code>, 1 Configuration, 1 View
configuration, 3 Repeater,
8 <code> 1 1 3
Press key to confirm.
Press keys
through the configured loops.
:xxx
:xxx
:xxx
Press key to view the control panels in
= rr
the network.
The CONF line shows the enrolled control
3
panels that are connected to the network.
The FAULT line shows the enrolled control
panels that are not connected to the
network.
Initialising the configuration/programming from panel
Programming Manual
and to navigate