Table of Contents
Advertisement
6.2
Procedure to Restore Factory Settings
The AN-80i features a method to gain access to the CLI command prompt for a unit
where the IP address, username, and/or password is unknown. This method requires
local access to the AN-80i PoE power adapter, the ability to power-cycle the AN-80i, a
PC with a telnet client, and an Ethernet cable.
Use the following steps to gain access to the CLI command prompt:
Power-off the AN-80i PoE adapter. Remove the local network Ethernet cable and
1.
connect your computer directly to the PoE adapter DATA (INPUT) Ethernet port.
Open a command prompt window on the PC and enter the command:
2.
Restore power to the AN-80i PoE adapter and wait for 10 seconds.
3.
Power-off the AN-80i PoE adapter for 5 seconds (7 seconds maximum).
4.
Restore power to the AN-80i PoE adapter and wait for approximately 20 seconds.
5.
Press the Enter key on the PC (start the Telnet session). When the login prompt
6.
appears, you have approximately 30 seconds to login using 'admin' as the user
name and 'admin' as password. After login, all AN-80i CLI commands are available.
If the login prompt does not appear, re-enter the Telnet command (up to 60 seconds
from power-on). If this is not successful, repeat steps 2 to 6 using a wait time in step
5 (30 to 40 seconds).
Use the following command to restore the default IP address, username and
7.
password:
The following parameters are not affected by the 'save defaultconfig' command:
System Name, System Location, System Details and Contact
-
Frequency list
-
SNMP configuration
-
ID table (PMP only)
-
Power-off the PoE adapter and re-connect the network cable. Restore power to the
8.
PoE adapter.
70-00072-01-07
&
AN-80i
Figure 38: CLI - Recovering Lost IP Address
telnet 192.168.25.2
save defaultconfig <Enter>
Proprietary Redline Communications © 2008
<Do not press Enter key at this time>
Page 85 of 106
User
Manual
Sept 18, 2008
Advertisement
Table of Contents
