Redline RedCONNEX RedACCESS AN-80IE User Manual page 76

PTP PMP Parameter/Description
√
enckey: Enter the encryption key. If encryption is enabled, the correct
encryption keys must be entered on both communicating systems. Used only if
encmode is set to 'on'.
<mac>
√ √
ethmode: Enter the Ethernet speed and duplex setting.
√
exit: Exit from the current mode (go up one level).
√ √
flowctrl: Enable or disable the flow control function. The Flow control feature
enables the AN-80i to request other Ethernet devices to pause transmission
during busy periods.
√ √
gateway: Enter the IP address of the default gateway on this segment.
√ √
gmt: Enter the time offset from GMT (i.e., -5 for EST).
√ grppri: Group priority.
<id>
<pri>
√ grpqos: Group QoS.
<id>
<qos>
√ grprate: Group rate.
<id>
<rate>
√ grpvid: Group VLAN ID.
<id>
<vid>
√ grpviden: Group VLAN enable.
<id>
<mode>
√ √
http: Enable or disable the HTTP function. When disabled, the Web interface
will not be available.
√ idname: ID name.
<id>
<name>
√ lkname: Link name.
<name>
√ √
ipaddr: Enter the IP address and subnet mask of the AN-80i.
Address
Mask
Yes
70-00072-01-07
Proprietary Redline Communications © 2008
&
AN-80i
Table 36: CLI - set
- <MAC address>
auto - Auto-negotiate
10hd - 10Base-T Half Duplex
10fd - 10Base-T Full Duplex
10hd - 100Base-T Half Duplex
100fd - 100Base-T Full Duplex
off - Disable
on - Enable
- [id number]
- <VLAN priority>
- [id number]
- <QoS>
- [id number]
- <group rate>
- [id number]
- <VLAN ID>
- [id number]
- <on/off>
off - Disable
on - Enable
- [id number]
- <id name> - maximum 15 characters
- <id name> - maximum 15 characters
- IP Address
- Subnet Mask
- Confirmation to proceed
User
Manual
Page 76 of 106 Sept 18, 2008