Redline RedCONNEX RedACCESS AN-80IE User Manual page 78

PTP PMP Parameter/Description
√ snmptraps: Status of the SNMP traps flag.
<mode>
√ snmptraps: Enable or disable sending all SNMP traps.
<setting>
√ √
sntp: SNTP enable setting.
√ √
sntpip: Enter the SNTP server IP address. Valid only if sntp is enabled.
√ √ sntppoll: Enter the interval to synchronize with the sntp server.
<polltime>
√ sstoss: Status of packet routing between SSs.
<id>
<mode>
√ √
syscontact: Enter additional descriptive details about this AN-80i. The
description can be any combination of up to 20 letters and numbers.
√ √
sysdescr: Enter descriptive details about this AN-80i. The description can be
any combination of up to 20 letters and numbers.
√ √
sysloc: Enter descriptive details about the location of this AN-80i. The
description can be any combination of up to 20 letters and numbers.
√ √
syslog: Syslog enable setting.
√ √
syslogip: Enter the syslog server IP address. Valid only if syslog is enabled.
√ √
sysmode:
PTP Operation:
ptpsector controller - The sector controller (base station) begins
ptpsubscriber - Subscriber waits passively, monitoring the selected
PMP Operation:
pmpsc - The sector controller (base station) begins transmitting
pmpss - Subscribers wait passively, monitoring the selected channel(s)
<SysMode>
√ √
sysname: Enter the name for this AN-80i. The name can be any combination
of up to 20 letters and numbers.
√ √
telnet: Enable or disable the Telnet port. If the Telnet port is disabled, it will not
be possible to use the CLI interface.
Changes to this field are effective only following reboot.
√ √
telnetport: Enter Telnet port address (default is 23).
70-00072-01-07
Proprietary Redline Communications © 2008
&
AN-80i
Table 36: CLI - set
- [on | off]
- [on | off]
off - Disable SNTP protocol support.
on - Enable SNTP protocol support.
- SNTP polling interval [hours].
- [id number]
- <on/off> - Route broadcast packets from SS to SS
off - Disable syslog server protocol support.
on - Enable syslog server protocol support.
transmitting automatically; sending poll messages to locate the
remote subscribers (ptpsubscriber).
channel(s) until polled by the ptpsector controller (base station).
automatically; sending poll messages to locate the remote
subscribers (pmpss).
until polled by the pmpsc (sector controller).
- [pmpss | pmpsc]
off - Disable
on - Enable
User
Manual
Page 78 of 106 Sept 18, 2008