System Information; General Information; Dashboard; Table 2: Wireless Link Led Diagnostics - Redline RedCONNEX RedACCESS AN-80IE User Manual

Table of Contents

Advertisement

3.3

System Information

3.3.1

General Information

Click
General Information
System Configuration

Dashboard

The dashboard display at the top of the
important operational information including: the unit IP address, operating frequency,
current time (web user's platform), wireless status, Ethernet status, Received Signal
Strength Indication (RSSI), Signal to Interference, Noise, and Distortion Ratio (SINADR),
and the radio temperature.
IP Address (top left of screen): Current IP address setting of this unit.
Wireless Frequency (top center of screen): User-assigned RF channel frequency.
Time (top right of screen): Displays time obtained from user's Web browser.
Wireless Link LED
The Wireless Link LED lights solid green when the wireless link is established. If the
LED is off, it may indicate one of the problems listed in the following table:
Symptom
No wireless
link
Wireless Signal LED
The wireless signal LED lights when a wireless link is established. Signal indications are
different based on the Adaptive Modulation setting:
70-00072-01-07
AN-80i
to view the system overview screen (read-only). Refer to the
screen for information about changing these settings.

Figure 7: Web - General Information Dashboard

Table 2: Wireless Link LED Diagnostics

Possible Problem
Link name does not match. A PTP
wireless link can be established
only between pairs of AN-80i
systems having identical Link
Name settings.
Remote system is malfunctioning
or is not powered-on.
The propagation path is blocked.
The transceiver is malfunctioning.
Antenna is not aligned with the
remote system.
Proprietary Redline Communications © 2008
&
General Information
Solution
Enter identical Link Name field settings
on master and slave units. To establish a
PTP wireless link between an AN-50e
and AN-80i system, the AN-80i Link
Name field must be blank (delete all
characters).
Verify operation of remote system.
Clear path or re-locate unit.
Repair/replace unit.
Re-align the antenna.
Page 20 of 106
User
Manual
screen shows summary of
Sept 18, 2008

Advertisement

Table of Contents
loading

This manual is also suitable for:

Redconnex redaccess an-80i

Table of Contents