Table of Contents
Advertisement
5.3.14 Save
Use the save command to copy edited parameter settings into non-volatile memory.
save [option] <Enter>
PTP
PMP
√
√
5.3.15 Script
Use the script command to save a file containing a string of CLI commands that can be
used to restore the current (active) configuration of the AN-80i. Saved configuration files
can be viewed, copied, and/or modified using a text editor.
The file will be saved in the TFTP default directory. The filename may be any name and
extension valid for the TFTP server platform. It is recommended use a filename that
uniquely identifies the An-80i unit and the current date (e.g., Red80-AD0023-
080723.cfg).
See also 'loadscript' command.
PTP
PMP
√
√
5.3.16 Set
Use the set command to view and/or change a parameter.
View a parameter:
set [field] <Enter>
Change a parameter:
set [field] [value] <Enter>
PTP
PMP
√
√
70-00072-01-07
AN-80i
Table 34: CLI - save
Parameter/Description
config: Save Ethernet, wireless, and user configuration settings.
snmp: Save SNMP settings.
defaultconfig: Overwrite parameters with the factory default settings. The
following settings are not affected: system name, location, details and contact,
frequency list, SNMP configuration, IDs table (PMP only).
Table 35: CLI - script
Parameter/Description
script
<server>
- [TFTP server IP address]
<name>
- [script file name]
Table 36: CLI - set
Parameter/Description
activekey: Current active options key.
<active_idx>
- [ 0 | 1]
adaptmod: Enable or disable the adaptive modulation function.
off - Disable
on - Enable
When enabled, the AN-80i will automatically change the modulation to the
highest setting that can sustain a packet error rate lower than 1x10e-6. If the
packet error rate exceeds 1x10e-6, the system automatically steps down
modulation/code rate (i.e., from 16 QAM 3/4 to 16 QAM 1/2 ) to maintain the
wireless link quality.
Proprietary Redline Communications © 2008
&
Page 73 of 106
User
Manual
Sept 18, 2008
Advertisement
Table of Contents
