Table of Contents
Advertisement
a pass-through
Group
controller Ethernet ingress port are discarded.
Packet received at sector controller Ethernet interface: The packet is forwarded
unmodified over the wireless to all subscribers in this
Packet received at sector controller wireless interface (from subscriber): The packet
is forwarded unmodified over the wireless to all subscribers in this
If the sector controller Ethernet port is enabled, the packet is also forwarded to the
sector controller Ethernet port.
Group VLAN ID: Enter the VID associated with this
This field is used only when 'Tagged' is selected in the
Default Priority: Enter the default 802.1p priority setting.
The default priority setting is used only when the
through' mode and the associated
Default Priority value is used when adding the 802.1Q tag (
packet being forwarded.
SC Ethernet Enable: Controls the sector controller Ethernet port.
Check this box
to allow ingress and egress data traffic on the sector controller
Ethernet interface. Uncheck this box ( ) to block all data traffic on the sector controller
Ethernet interface. The sector controller Ethernet port remains available for management
traffic.
SS To SS Multicast Enable:
Check this box
to enable group multicast traffic between subscribers.
Uncheck this box ( ) to block all multicast traffic between subscribers.
Wireless Traffic Parameters
Changes to these settings affect the CIR and PIR for all groups and connections on the
wireless link.
Group QoS Level: This setting represents the range of CIR available to
for downlink multicast/broadcast traffic.
It is strongly recommended to calculate the
PMP Configuration Tool -- the
Group ID Configuration
having the lowest UBR and calculate the
Link
. A zero setting disables all DL broadcast and multicast traffic for this group.
Rate - 1
Rate: Enter the maximum downlink burst rate for this
It is recommended to use the 'auto' setting where the AN-80i selects the most reliable
rate. To manually determine this value, identify the
burst rate, and then set the
requiring a higher broadcast/multicast rate (e.g., video), a higher setting can be used at
the risk of less reliable retransmissions.
70-00072-01-07
Proprietary Redline Communications © 2008
&
AN-80i
is not configured, all untagged packets received at the sector
Connection Tagging Mode
Group QoS level
section. To manually determine this setting, identify the member
using the formula:
Rate
.
Group
definition.
Group
Tagging Mode field.
Group
Group Tagging Mode
is set to 'Tagged'. The
Connection
using the Redline AN-80i
Group QoS Level
can be read from the
using the formula:
Group QoS Level
.
Group
member having the lowest DL
Group
Max DL Burst Rate - 1
Page 54 of 106
User
Manual
.
Group
is set to 'pass-
Group
VLAN ID) to the
members
Group
column in the
QoS
Burst
. For applications
Sept 18, 2008
Advertisement
Table of Contents
