Table of Contents
Advertisement
Uncoded Burst Rate [Mb/s]: Select the desired UBR for the link. If Adaptive Modulation
is disabled, the AN-80i will transmit using only the specified settings. See Table 10:
Maximum TX Power Settings (dBm) for AN-80i Radio.
Channel Width [MHz]: Select the channel bandwidth. Refer to Table 63: Spec. -
Regional Identification Codes on page 99 for available channel widths.
Ethernet Follows Wireless: Check this box
the Ethernet port function based on the status of the wireless interface. This feature
allows switches and routers to trigger configuration changes based on changes to the
AN-80i Ethernet port status.
Disabled ( ): The AN-80i Ethernet port is always enabled.
Enabled ( ):Ethernet port is controlled based on the status of the wireless interface.
Table 11: Web - Ethernet Status Indication
Wireless interface Status
Link Down
Important: The
Ethernet Follows Wireless
traffic (HTTP, TELNET, and SNMP). While activated, it is not possible to manage the
AN-80i using the Ethernet port.
Ethernet follows wireless timeout [sec]: Enter the period (in seconds) the Ethernet
port will remain disabled following loss of connectivity on the wireless interface.
Following this interval, the Ethernet port will be automatically re-enabled to allow
management of the AN-80i.
Important:
When
switches/routers monitoring the Ethernet port must be programmed to not switch
automatically when the Ethernet port function is restored -- the wireless interface may
not be operational.
System Mode: Set the operating mode for each AN-80i system.
PTP Master: This unit begins transmitting automatically; sends poll messages to the
remote AN-80i, and negotiates the wireless link.
PTP Slave: This unit waits passively, monitoring the selected channel(s) until polled
by the PTP Master, and participates in negotiating the wireless link.
Software Version: Select the version of system software to load when the AN-80i is
rebooted. The system holds two independent software images.
Encryption Type: Select an encryption type for data transmitted over the wireless
interface. When encryption is enabled, no Ethernet packets can be transferred over-the-
air unless encryption is enabled on the remote-end AN-80i and the correct Encryption
Key is entered on both AN-80i units.
None: Encryption is disabled.
Redline 64-bit: Redline proprietary encryption scheme, compatible with AN-50e.
AES 128-bit: Advanced Encryption Standard using 128-bit encryption.
AES 192-bit: Advanced Encryption Standard using 192-bit encryption.
AES 256-bit: Advanced Encryption Standard using 256-bit encryption.
70-00072-01-07
Proprietary Redline Communications © 2008
&
AN-80i
Link Up
Ethernet
Follows
Wireless
to have the AN-80i disable and enable
Ethernet Port Status
Enabled
Disabled
setting affects all data and management
is
Timeout
Page 37 of 106
User
Manual
enabled,
external
Sept 18, 2008
Advertisement
Table of Contents
