Connecting With Telnet; Cli Command Set; Chgver; Table 20: Cli - Root Mode Commands - Redline RedCONNEX RedACCESS AN-80IE User Manual

PTP PMP
√ √
√ √
√ √
√ √
√ √
5.2

Connecting with Telnet

To connect to the AN-80i, open a Telnet session to the IP address of the AN-80i. On a
Windows™ PC, open the Run command and type 'telnet' followed by the IP address of
the AN-80i. When the command prompt screen appears, login to the AN-80i. The AN-80i
may now be controlled using a set of CLI commands.
The system will logout users automatically if no commands are received (idle) for five
minutes. To exit immediately from the CLI, type the following command:
logout [ENTER]
The AN-80i supports two concurrent Telnet sessions. One session has full capabilities
and the second session is read-only (e.g., monitor or show parameter settings).
5.3

CLI Command Set

5.3.1

Chgver

Use the chgver command to change the software version loaded when the AN-80i is
rebooted.
PTP PMP
√ √
70-00072-01-07
AN-80i

Table 20: CLI - Root Mode Commands

Command Description
When entering a command, hit the Tab key at any time to perform
Tab
auto-complete or view available options.
Use the '?' character to display help for any command or mode.
?
Example: From the root directory, enter the following command to
list all parameters that can be changed using the 'set' command:
set ?
Return to root mode.
CTRL-Z
Cancel command entry (alternative to backspace delete).
Return to parent node / mode.
exit
all (exit all) Return to root mode.
Terminate this telnet session. May be entered from any mode.
logout

Figure 37: CLI - Connecting via Telnet

Table 21: CLI - chgver

Parameter/Description
Enter this command to toggle between software versions. The setting will
alternate between the two banks of memory (no parameters).
chgver <Enter>
Proprietary Redline Communications © 2008
&
Page 67 of 106
User
Manual
Sept 18, 2008