5.3.18 Snmpcommunity; 5.3.19 Snmptrap; 5.3.20 Test; Table 38: Cli - Snmpcommunity - Redline RedCONNEX RedACCESS AN-80IE User Manual

5.3.18 Snmpcommunity

Use the snmpcommunity command to configure SNMP community permissions.
PTP
√

5.3.19 Snmptrap

Use the snmptrap command to configure the SNMP trap message reporting.
PTP PMP
√ √

5.3.20 Test

Use the test command to load the current edited (but not permanently saved)
configuration settings.
PTP PMP
√ √
70-00072-01-07
AN-80i

Table 38: CLI - snmpcommunity

PMP Description
√ add: add a new snmp community to the snmp community table. The
index value is assigned automatically. Up to eight community entries can
be entered in the table.
snmpcommunity add <name> <string> <Enter>
snmpcommunity add <rights> 0 | r | w | rw <Enter>
Where.
0 (zero):Deny read and write permission.
r: Grant read access permission only. Deny write permission.
w: Grant write access permission only. Deny read permission.
rw: Grant read and write access permission for this community.
default: Set all snmp parameters to factory default settings.
snmpcommunity default <idx> <Enter>
del: Delete the specified community entry.
snmpcommunity del <idx> <Enter>
print: List all SNMP communities and associated permissions.
snmpcommunity print <Enter>

Table 39: CLI - snmptrap

Description
add: add a new snmp trap to the snmp trap table. The index value is assigned
automatically. Up to eight settings can be entered.
snmptrap add <ipaddr> <port> <community> <Enter>
change: Modify the specified snmp setting.
snmptrap change <idx> [-p <port>] [-i <ip_add>] [-c <community] <Ent>
del: Delete the specified snmp setting.
snmptrap del <idx> <Enter>
print: List all SNMP trap settings.
snmptrap print <Enter>

Table 40: CLI - test

Parameter/Description
config - AN-80i configuration settings
test config <Enter>
Proprietary Redline Communications © 2008
&
Page 82 of 106
User
Manual
Sept 18, 2008