Site Survey; General Information; Network Settings; Radio Management Settings - Redline Connect Series Installation Manuallines

RDL-3000 Connect-OW-OW
3

Site Survey

It is recommended to perform a site survey before installing the Connect-OW system.
The data accumulated during this process is necessary to understand the operating
characteristics and obtain the best performance from the wireless system.
3.1

General Information

The General Information fields uniquely identify each installed system. It is
recommended to record this information prior to installation.
Setting
Name
Details
Location
Contact
3.2

Network Settings

The Connect-OW must be assigned a unique IP addresses before it is connected to the
base station and the local area network (LAN). When DHCP is enabled, the remaining
settings are populated automatically by the DHCP server.
Setting
DHCP Enable
IP Address
Subnet Mask
Default Gateway Address
Ethernet Mode
3.3

Radio Management Settings

The following table contains the minimum set of parameters required to configure the
wireless interface. Note that these settings are made independently of the Serial
Gateway settings using the
Parameter
System Name
TCP/IP Address
Channel Size
RF Freq.
Tx Power
Antenna Gain (DFS only)
70-00200-01-00
Installation Guidelines

Table 8: Site Survey - General Information Settings

Radio Management
Table 9: Site Survey - Network & Syslog Server Settings
Radio Management
Radio Management

Table 10: Site Survey - Radio Management Settings

Value
Proprietary Redline Communications © 2014
selection.
Page 25 of 58
Chapter 3
December 3, 2014