Table of Contents
Advertisement
Wireless Configuration
Use settings on the following screen to configure the AN-80i wireless interface.
Figure 12: Web - Wireless Configuration Screen
RF Freq. [MHz]: Enter the center frequency for the RF channel. This setting must be
identical for both AN-80i systems operating as a wireless link. The options key controls
channel availability. Refer to Table 63: Spec. - Regional Identification Codes on page 99
for available channels. Use the Autoscan feature to enable use of multiple channels.
When the Auto Scan field is not checked, the PTP Slave will only register with a PTP
Master operating at the frequency specified in the RF Freq. [MHz] field.
Important: To minimize interference, the channel frequencies for AN-80i links
operating in close proximity should be separated by a minimum of the channel size in
use (to avoid overlapping bands).
Auto scan: Check this box
channels to locate and register with an AN-80i PTP Master. When the Auto Scan field is
checked, click on the blue text
70-00072-01-07
Proprietary Redline Communications © 2008
&
AN-80i
to enable the PTP Slave automatically scan available
[
]
adjacent to the check box to display
Frequency Ranges
User
Manual
Page 33 of 106
Sept 18, 2008
Advertisement
Table of Contents
